Triumph Speed Triple Forums banner
1 - 2 of 2 Posts

· Registered
Joined
·
1,004 Posts
Discussion Starter · #1 ·
I want to build a custom pipe for my 1050. I want to tuck a small conical can into the area under the rider peg (right side). In order to do this I will have to cut the header pipe right behind the collector. Is this where the pre cat is located? I want to know if this will affect tuning much, is this ill-advised? I would end up leaving enough pipe there for a O2 sensor bung, and a slip fit can (about 1.5-2"). I hear that you may be doing the header mods/ coating on an exchange basis? I am very interested in this, along with the cool air kit you have posted. I am sorry to bug you, but from what I have read, you are the guy to ask. ;)
 

· Registered
Joined
·
1,004 Posts
Discussion Starter · #3 ·
Thanks Alaska, I thought that was right, but I have learned never to trust my intuition. I trust my instinct instead, so I smash thigs and wreck alot ;D
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top