Triumph Speed Triple Forums banner

bar end mirrors

916 Views 3 Replies 2 Participants Last post by  StuckInKansas
G
Ok, I'm a complete noob on how this would work. My stock bar end weights spin freely. How do I go about putting on some bar end mirrors if they won't even stay in place? Do I have to buy a new handlebar and 7/8 bar end weights so that I can attach them? Or do I just need to buy new bar end weights that won't move freely on the handlebars? I feel like this should be a lot easier than I'm making it. Oh yea, it's on my honda 919.
1 - 4 of 4 Posts
Can you remove the stock bar ends? If so you can go with the CRG set-up easily enough. CRG makes the mirrors and the bar ends they mount on.
G
Yea, there's just a screw that goes in through the bar end. I'll have to look into that then.
Remember to push on the bolt after its loosened a bit. You will hear a snap, and then they will come right out.
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top