Joined
·
3,665 Posts
1 - Remove master cylinder cap.
2 - Fill MC with fluid and replace cap.
3 - Connect hose (Tygon, etc.) to bleed valve. Place open end of hose in jar or bottle.
5 - Loosen bleed valve, squeeze lever slowly, but firmly. While holding lever compressed, tighten bleeder valve.
Repeat until clear fluid comes out of hose on calipers. When MC becomes 3/4 EMPTY, add fluid.
Move to other caliper and start again.
The use of easy bleeders, will allow you to not have to tighten bleeder valve between compressions of lever.
2 - Fill MC with fluid and replace cap.
3 - Connect hose (Tygon, etc.) to bleed valve. Place open end of hose in jar or bottle.
5 - Loosen bleed valve, squeeze lever slowly, but firmly. While holding lever compressed, tighten bleeder valve.
Repeat until clear fluid comes out of hose on calipers. When MC becomes 3/4 EMPTY, add fluid.
Move to other caliper and start again.
The use of easy bleeders, will allow you to not have to tighten bleeder valve between compressions of lever.
