Triumph Speed Triple Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
4,519 Posts
Do you have the manual and follow the bolt torque sequence? I've printed it below just in case. It worked for me the only time I had to do it.

1. Fit new seals to the cylinder head.
Note:A smear of grease may be used to retain the seals in the cylinder head during assembly

2. Locate the down-pipe and align the flanges to the cylinder head.

3. Assemble the rear mounting point fixings but do not tighten at this stage.

4. Tighten the downpipe to cylinder head fixings in the following sequence:
a) Working from left to right, tighten the upper row of nuts to 19 Nm.
b) Working from left to right, tighten the lower row of nuts to 19 Nm.
c) Working from left to right, re-tighten the upper row of nuts to 19 Nm.

5. Tighten the rear mounting point fixing to 15 Nm
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top