Triumph Speed Triple Forums banner
1 - 3 of 3 Posts

· Registered
6,909 Posts
Discussion Starter · #1 ·
Very nice quality and went on easily enough with some 3M tape (thick gray stuff wrapped in red). You can see the lower frame protector in the bottom pic. I'll need to modify the solo cowl as it doesn't have the standoffs for the rear screws... I think just epoxying in some delrin should take care of it. Now if I can just find some delrin blocks...

1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.