Triumph Speed Triple Forums banner

Rizoma Bars

922 Views 2 Replies 2 Participants Last post by  J-Pip
Rizoma fat bars arrived today complete with risers and grips - anyone know what torque settings should be to headstock and bar clamps?? Also advice on fitting twist grip assembly and throttle cables please.

;D :beer:
1 - 3 of 3 Posts
I don't have it on this computer, but will check it when I get home.
Ok the top nut should be tightened to 90NM, the adjuster nut at 40nm. The bar clamps 26NM

The headstock adjuster seems a bit complicated. The manual states to tighten to 40, slacken, tighten to 15 and then tighten to 40.
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.